Deleting The Gnss Receiver Position - Safran VersaSync User Manual

3.3.3.8

Deleting the GNSS Receiver Position

The VersaSync timing system requires the exact geographic position in order to
calculate the exact system time from the GNSS signal.
The Delete Position command deletes the GNSS antenna position data that is
stored in the non-volatile memory of the GNSS receiver.
The deletion of the position data will automatically initiate a new GNSS self sur-
vey, provided:
The objective of the GNSS Survey is to re-discover the current antenna position.
Relocating VersaSync
The Delete Position command may need to be used if a VersaSync system is
physically moved, and it did not self-initiate a new survey automatically. Note
that neglecting to delete the old position data and discover the new position data
will cause VersaSync not to go into synchronization state.
CHAPTER •
3 VersaSync User Manual Rev. 12
1. Navigate to Interfaces > References: GNSS Reference
2. Click on the GEAR button next to the GNSS Reference. The
dow opens:
3. Locate the Reset Receiver
a GNSS antenna is connected to VersaSync
the GNSS receiver can track at least four satellites continuously
and the GNSS receiver it is configured to operate in
Note: A self survey
box, check it, and click Submit.
will take at least 2000 seconds (33 minutes).
3.3 Managing References
GNSS 0
Standard Mode.
win-
209