Safran VersaSync User Manual page 328

APPENDIX
e. Commands need to be typed in all lower-case letters.
f. Where eth0 and eth1 are the base network ports.
g. User accounts with "user" group permissions can perform "get" commands
agnss server
agnss server disable
agnss server enable
agnss server gen
agnss server station
agnss server record
agnss server all
agnss server status
agnss server time
agnss server age
agnss server rnx
clean
cleanhalt
314
but cannot perform any "set" commands or change/reset passwords. Only
user accounts with "admin" group permissions can perform "set" com-
mands or change/reset password. Refer to
User Accounts" on page 244
Command
Display AGNSS status ie. enabled or disabled
Disable AGNSS server
Enable AGNSS server
Display almanac generation configuration.
<daily <HH:MM>|interval> Use with arguments to set the
almanac generation configuration to either daily with 24hr
gen time each day or an interval in s between 10 and 86400
Display AGNSS station
<station> Use with arguments to set AGNSS station to a 4-
letter station name.
Display the time in days the records are kept.
<days> Use with argument to set the time the records are
kept between 2 and 400 days.
Display all AGNSS information; combines status, time age and list com-
mands.
<ephemeris|almanac> Display Ephemeris or Almanac data status.
<ephemeris|almanac> Display time in seconds until next data set is
ready.
<ephemeris|almanac> Display data age in seconds.
<GPS|GLO|GAL|BEI> Display list of constellations's satellites found in
today's RINEX file.
Restores VersaSync configuration, logs, and stats to factory defaults
and reboots
Restores VersaSync configuration to factory defaults and halts
"Adding/Deleting/Changing
for user account setup information.
Description
VersaSync User Manual