Safran VersaSync User Manual page 45

CHAPTER •
2 VersaSync User Manual Rev. 12
2. Connect the power supply. The unit will power up, and the ON/OFF status
LED will pulsate.
Requirement
Power up Connect 12 V
power connector.
Caution:
installation using your cables, check the polarity of the wires
and confirm that the unit will power up normally before pro-
ceeding with these steps or making any other connections.
3. Install the GNSS antenna(s). Follow your antenna manufacturer's instruc-
tions. :
For additional information on GNSS antenna installation considerations,
including cabling, an Orolia tech note is available here.
4. Wire the antenna cables and interface cables. Most customers will require
the Multi I/O and Ethernet cables for these connections, as well as a PC..
Requirement
USB con- Connect USB to the Multi
nection I/O connector.
Network con- Connect at least one of
nection the two Ethernet con-
nectors to a network.
USB: Connect the
are using the Evaluation Kit, connect the Multi I/O USB output to a
PC. Install a
®
PuTTY ).
Ethernet: Connect the
unit. If you are using the Evaluation Kit, connect at least one of the
two I/O cable Ethernet ports (ETH0 or ETH1) to a network
switch/hub, or to the PC mentioned above (using a standard Ethernet
patch cable, or a crossover cable).
For pinout tables, see
figuring Inputs/Outputs" on
Action
to the Attach a cable and apply 12 V
DC
labeled "Main" (CA08R-CRPB-0002)
If your unit does not power up, and this is your first
Action
Multi I/O connector to the VersaSync unit. If you
terminal emulator program on the PC (e.g., TeraTerm
Ethernet cable to one of the ETH ports of the
"Connectors and their Pinouts" on page 10
page 43.
2.2 Installation Overview
Evaluation kit cable
Evaluation kit cable
Connect the USB connector to a PC with a
terminal emulator program (CA08R-
CRUB-0002)
Connect the RJ45 jack labeled ETH0 or
ETH1 to a network hub/switch or directly
to a PC (CA08R-CRET-0002)
to the plug
DC
®
or
and "Con-
31