Safran VersaSync User Manual page 65

First, assign a GPIO output to an I/O pin pair:
Then, configure the settings for the newly created output:
CHAPTER •
2 VersaSync User Manual Rev. 12
1. In the Web UI, navigate to
Pin Layout screen will be displayed.
2. Prior to assigning the new output, identify a pin pair in the Pin Layout table
that is not used (Signal = "None") or not needed. You can
may also simply assign the new PPS Output as described below, thus over-
writing the existing Input or Output.
3. Add a pin configuration by clicking the PLUS icon in the top-right corner
(1). The Add Pin
4. Start with the Type Filter
select DCLS_TTL.
5. From the Signal
6. From the Pins drop-down menu in line 3, select e.g., pins 1,2.
7. Click Submit.
8. In the Actions panel, click
9. Navigate to INTERFACES > OUTPUTS > General Purpose Output/GP Out-
put 0. The GP Output 0
10. Click Edit. The GP Output 0
11. Under General, set the
Enabled.
MANAGEMENT > NETWORK: Pin
window will display.
drop-down menu (second line in the window) and
drop-down menu, select
Apply Changes.
status window will be displayed.
configuration window will be displayed.
Output Mode
2.7 Configuring Inputs/Outputs
GPIO_OUT DCLS_TTL.
to Square Wave, and check
Layout. The
Delete it, but you
Output
51