Safran VersaSync User Manual page 218

Hide thumbs Also See for VersaSync:
Table of Contents

Advertisement

3.3  Managing References
204
Note:
This option only applies to the
device, not to SAASM GPS receivers (if equipped).
Caution:
If you select a setting that does NOT resurvey, and
subsequently relocate your unit (antenna) by more than
100 m, the receiver will NOT detect the new position, and
hence provide an incorrect time.
The following Receiver Dynamics exist:
Land (Resurvey/No
When used with the Mobile Receiver Mode, the receiver is adjusted
for typical dynamic land-based applications.
When used with the Standard Receiver Mode, this setting also will
automatically initiate a resurvey after VersaSync reboots, in order to
account for a possible relocation.
Sea: The receiver dynamics will be optimized for mobile motion pat-
terns typical with marine applications, resulting in greater timing
accuracy, and avoiding premature loss of synchronization.
Air: The receiver dynamics will be optimized for acceleration forces
typically experienced in civil aviation applications.
Stationary (No
non-dynamic value for stationary applications; there will be no auto-
matic resurvey after a reboot. Hence, should a unit be relocated, you
need to delete its position, thus initiating a new survey.
The following table summarizes the different settings and their inter-
dependencies:
Mode
Application
Mobile
mobile
Resurvey):
Resurvey): In Standard Mode, the receiver is set to a
Survey?
Never
CHAPTER
M8T
receiver in your
(Re-)Survey –
When?
Never
Land
Air
Sea
3
VersaSync User Manual Rev. 12
Receiver
Dynamics

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VersaSync and is the answer not in the manual?

Table of Contents