Safran VersaSync User Manual page 60

2.7 Configuring Inputs/Outputs
architecture.
The table below illustrates the signal combinations that can be assigned to the 18
configurable pins.
Table 2-3:
Notes:
Pins to Channels (e.g., pins 3 & 4= Channel 1)
green
two Channels)
red = This Signal Message type cannot be assigned to this Channel
ATC = ASCII Time Code
Configuring a new Input or Output
1. In the VersaSync Web UI, navigate to
2. Prior to assigning the new output, identify a pin pair in the pin
46
I/O signal mapping to Channels
= Signal Message Type can be assigned to this Channel (RS485 requires
out. The Pin Layout screen will be displayed.
that is not used (Signal = "None") or not needed. You can
may also simply assign the new PPS Output as described below, thus over-
writing the existing Input or Output.
MANAGEMENT > NETWORK: Pin Lay-
Delete
CHAPTER •
2 VersaSync User Manual Rev. 12
Layout table
it, but you