Safran VersaSync User Manual page 150

2.8 Configuring Network Settings
NTP utilizes the NTP.conf file for its configuration. Normally, configuration of this
file is indirectly performed by a user via the integrated configuration pages of the
VersaSync Web UI. However, it may be desired in certain circumstances to edit
this file directly, instead of using the web- based setup screens. When Expert
Mode is enabled, the user has direct access to the NTP.conf file.
136
Caution: Safran Tech Support does not support the editing of the
NTP configuration files while in the Expert Mode. For additional
information on editing the NTP.conf file, please refer to
http://www.ntp.org/.
Note: IMPORTANT: If an undesirable change is made to the NTP.-
conf file that affects the NTP operation, the NTP.conf file can be
manually changed back as long as the previous configuration was
known.
The NTP.conf file can be reset back to the factory default values by either
using the procedure to restore all of the VersaSync factory default settings
(see "Restoring the Default NTP Configuration" on
file back to the original configuration as shown in the factory default con-
figuration below.
Caution: If changes are made to the NTP.conf file while in the Expert
mode, Expert mode should remain enabled from that point forward.
Disabling Expert mode after changes being made to this file may res-
ult in loss of this configuration information.
page 114) or editing the
CHAPTER •
2 VersaSync User Manual Rev. 12