Mounting; Selecting A Mounting Location - Safran VersaSync User Manual

2.2 Installation Overview
5.
6. Using the Web UI,
2.2.2

Mounting

2.2.2.1

Selecting a Mounting Location

The unit is to be mounted on a plate, using six (6) through holes. The mounting
location must offer sufficient space to accommodate the unit and the cable con-
nectors, and it must be within cable reach to other connected devices, such as
the GNSS antenna. The unit can be mounted horizontally, or at any angle. The
chosen environment must not fall below IP 65 ingress protection standards.
32
Establish a network connection
face ("Web UI"). See
the USB driver installation and network address configuration.
Note: You can also use Zeroconf to access the Web UI (see
"Zero Configuration Setup" on
configure
Software-configurable I/O pins, see
Other VersaSync INTERFACES settings and MANAGEMENT settings
e.g., network settings, reference priorities (see
Settings" on page 70).
so as to allow access to the web user inter-
"Initial Network Setup" on page 34
the following:
CHAPTER
for information on
page 39).
"Assigning I/O Pins" on
"Configuring Network
•
2 VersaSync User Manual Rev. 12
page 44.