Safran VersaSync User Manual page 56

2.6 Setting up an IP Address
Assigning a Static IP Address Using the Web UI:
1. Enter the IP address identified during setup
2. Log into the Web UI as an administrator. The factory-default user name and
3.
4.
5. To verify that the address has been accepted, enter the static IP address
6. To continue with your configuration; see:
42
page 34) into the address field of your browser (on a computer connected
to the VersaSync network). If the network supports DNS, the hostname
may also be entered instead (the default hostname is "Spectracom"). The
start screen of the VersaSync Web UI will be displayed.
password are:
Username: spadmin
Password: admin123
If necessary, disable DHCP by navigating to MANAGEMENT > Network
Setup. In the Ports panel on the right, click the GEAR icon next to the Eth-
ernet Port you are using. In the Edit Ethernet Port Settings window,
uncheck the Enable DHCPv4 field. Do NOT click Submit or Apply until you
complete the next step to avoid error messages.
In the fields below the Enable DHCPv4 checkbox, enter the desired Static
IP address, Netmask, and Gateway address (if required). Click Submit.
For subnet mask values, see
into the address field of the browser and log into the Web UI again.
on page 70.
("Initial Network Setup" on
"Subnet Mask Values" on
"Configuring Network Settings"
CHAPTER
page 390.
•
2 VersaSync User Manual Rev. 12