Safran VersaSync User Manual page 168

2.8 Configuring Network Settings
1.
2. The
3.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the
VersaSync CLI:
There are two GPSD utility programs already incorporated into VersaSync;
GPSpipe and CGPS. Both can be used as commands within the CLI to view inform-
ation currently being sent via GPSD. Both commands use CTL + C to stop.
154
The GPSD Service panel:
allows you to toggle the service ON or OFF
lists the Service Port
the Gear Icon in the GPSD Service panel allows you to change the Ser-
vice Port information. If your GPSD setup changes and needs to be
reconfigured within your VersaSync, this is where you can reset the
service port.
Actions panel provides an option to restore the
The Receiver Status
vice:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Pre-
cision Statistics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength,
and Usage for each satellite.
gpsdserviceportget – Displays the GPSD service port
gpsdserviceportset – Sets the GPSD service port
panel lists the information required by the GPSD ser-
CHAPTER
(ON default state)
default configuration.
•
2 VersaSync User Manual Rev. 12