Led Patterns During Boot Sequence; Blackout Mode; Interfaces Overview - Safran VersaSync User Manual

1.4 Interfaces Overview
Icon
1.3.3.1

LED Patterns during Boot Sequence

For the first five seconds after power-up all LEDs will be OFF. Then the Power
LED will be blinking before it will be lit permanently. If you have configured your
unit to operate in Blackout Mode, this will take effect once the blinking cycle
ends.
1.3.4

Blackout Mode

All LEDs can be turned off via the Web UI.
The LED brightness level can be set from
able).
To disable all LED activity via the WebUI:
1.4

Interfaces Overview

All of VersaSync's interfaces are integrated into the unit's connectors, which are
located on the front panel:
6
Light
OFF
FAST
ON
OFF
FAST
HEARTBEAT
OFF
FAST
Navigate to MANAGEMENT > OTHER: LED
Brightness level to "0".
No network detected
Network malfunction detected (e.g., no auto-negotiation)
Network OK, configuration OK
Unit OK
Unit requires attention; check other status LEDs, see Web UI
"LED Lighting Patterns" on page 4
See table
Temperature OK
High temperature detected
63 (as bright as possible) to
CHAPTER
Meaning
Configuration, and set the
•
1 VersaSync User Manual Rev. 12
0 (not vis-