Power-Up Test Codes - Digital Equipment VAXstation 3100 Maintenance Manual

6 Testing
1.2.1 Power-Up Test Codes
The power-up test codes indicate no error, soft errors, status inf onnation, or
hard (fatal) error information. Any errors found by power-up tests are listed in
the power-up tests summary. These errors as well as the status of all devices
installed in the system are then stored
in
the configuration 1able (TEST 50).
Table 1-4 lisls the test numbers and the devices that are tested during that
particular test. To look at the status of a device, display the configuration
table (enter TEST 50 (T 50) at the console prompt>>>). The configuration
table lists every device in the system and also lists the results of the power-up
tests and self-test. It is updated each time self-test is run. Remember that the
configW'ation table contains the results of the power-up tests and self-test and
not the results of the system exerciser.
Table 1-4 Power-Up end Self-Test Commends
Test
Mnemonics Device
TF MONO Base video
TE CLK Time-of-year clock
TD NVR
Nonvolatile random access memory (RAM)
TC DZ Serial line controller
TB MEM Memory
TA MM Memory management unit
T9 FP
Floating point unit
TS
IT Interval timer
T7 STR0-1 RX23 diskette drive (model 30 with
ST506iSCSI)
T7 SCSI-A SCSI-A bus controller on the SCSI/SCSI MSC
module
T6 SCSI-B SCSI-B bus controller on the SCSI/SCSI MSC
module
T 6 and 7 SCSI-A and RZ22 and RZ23 disk drives
SCSI-B
T6 SCSI-A and RRD40 compact disc and adapter board
SCSI-B
T6
SCSI-A and RZ55 expansion box
SCSI-B