Openvms And Osf/1 Console Power-Up Test Displays; Summary; If The System Passes; Passes - Digital Equipment DECpc AXP 150 User Information

OpenVMS and OSF/1 Console Power-Up Test Displays

OpenVMS and OSF/1 Console Power-Up Test Displays
This section describes how to recognize when power-up tests

Summary

pass or fail in the OpenVMS and OSF/1 console. It also describes
what to do if the system fails the power-up tests.
Power-Up The power-up test display indicates tests that pass with the word
Test Display OK
Differences and an error code
After the system passes the power-up tests, it displays the
following message:
System power up OK.
After the system fails the power-up tests, it displays the
following message:
System power up tests detected error(s).
See your system documentation for more information.
If the system passes the power-up tests, it either boots the
If the System

Passes

selected operating system or halts in console mode, depending on
the system default settings.
Table 2–6 describes the steps that you must follow after the
If the System
system fails the power-up tests.
Fails
Table 2–6 Power-Up Test Failure Procedure
Step
1
2
2–8 Using the System
. It indicates tests that fail with double question marks
.
Action
If the system fails the power-up tests, turn the system
unit off, wait approximately 15 seconds, then turn it
back on again.
If the system continues to fail the power-up tests,
see the Customer Technical Information manual for
information on troubleshooting the system, running
diagnostics, and contacting your Digital service
representative.