Tz30 Tape Drive Removal - Digital Equipment VAXstation 3100 Maintenance Manual

VS 3100 (Model 40) System 121
S.
Push the IIDA back against the rubber stops then lift up the front of the
HDA and remove it from the frame.
6. Slide the HDA into the rubber stops on the new drive module/frame.
7. Screw in the two new screws supplied.
8. Position the jumpers on the new drive module to the same position as they
were on the old drive module you just removed (Figure 5--11).
CO"Nl!CTOll TO
llG"AL
HDA MODUU CONN•CTO ..
0
0
fa.--1
D
D
D
1§111
Ill
eo
D
D
D
D
D
o· . .
D
D
0
0
POWlll
CO"NICTOll
MA-Ufll·H
Figure 5-11 RZ23 Jumper Location
5.2.5 TZ30 Tape Drive Removal
The TZ30 tape drive is on the lower drive mounting panel.
1. Remove the system box cover (Section 5.2.1).
2. Remove both of the drive mounting panels (Section 5.2.2).
3. Disconnect the data cable from the back of the 1Z30.
4. Tum the drive mounting panel over and remove the four screws from the
TZ30. Support the TZ30 with one hand when removing the last screw.