Drive Mounting Panel Removal - Digital Equipment VAXstation 3100 Maintenance Manual

114 VS 3100 (Model
40)
System
2. Remove the two cover screws (Figure 5-3).
Figure 5-3 Cover Screw Locations
COVER
SCFll!W
LOC"TIONS
3. Slide the cover forward and up off the system box.
5.2.2 Drive Mounting Panel Removal
MA · K0911·11
The drive mounting panel consists of two separate panels. The top panel
contains the three RZ23 disk drives and the lower panel contains the RRD40
eou1pa-ct disc drive
aud
th~
TZ:JO taF
diive.
The :vp panel
m~_ : ;: be
removed
before the lower panel can be removed. Both panels must be removed to
remove the system module, graphics module, memory module, or the power
supply. The following procedure describes how to remove both the top and
lower drive mounting panels.
1. Remove the system box cover (Section 5.2.1).
CAUTION
You must note which cables connect to whkh drive when
disconnecting them from the system. Write the type of drive and
its
position on a piece of tape and wrap the tape around the connector
before disconnecting it. This will help you when reinstalling the drives.