Digital Equipment VAXstation 3100 Maintenance Manual page 219

198 Console Commands
• MKBxOO - Tape drive on SCSI-B bus at address ID x (0 to 7)
•
11
•
11
-
Resets boot device to the ESAO default device.
• BFLG - Set the default boot flags. The value must be a hexadecimal
number of up to eight characters. The value entered is not checked
for validity.
• HALT - Set the default halt action code. This code specifies the
default action the console should take for all error halts and power up
halts. The default value is stored in nonvolatile RAM and is retained
across power cycles. If the nonvolatile RAM fails for any reason, the
console initializes this field to the value of 2 (boot).
Value
• A 1 sets the default action to restart.
• A 2 sets the default action to boot.
• A 3 sets the default action to halt.
• KBD - Set the console keyboard layout-to l of the 16 supported as
follows:
Value
•
•
•
•
•
•
•
•
•
•
•
•
A 1 sets the keyboard layout to Deutsch .
A 2 sets the keyboard layout to Deutsch (Schweitz) .
A 3 sets the keyboard layout to English .
A 4 sets the keyboard layout to English (British/Irish) .
A 5 sets the keyboard layout to Espanol.
A 6 sets the keyboard layout to Francais .
A 7sets the keyboard layout to Francais (Canadien) .
An 8 sets the keyboard layout to Francais (Suisse Romande ) .
A 9 sets the keyboard layout to Italiano .
A 10 sets the keyboard layout to Nederlands .
An 11 sets the keyboard layout to Norsk .
A 12 sets the keyboard layout to Portugues .
A 13 sets the keyboard layout to Suomi.