Digital Equipment VAXstation 3100 Maintenance Manual page 245

224 Power-Up and Self-T.at Error Codes
Table E-17 (Cont.) Device Status Codes (DDMMSSTT)
Status Codes Deftnltton
58 Message in phase out of sequence
SA Stuck in message in phase
60 Target set data out phase (unexpectedly)
62 Target set phase to lOOb (reserved phase)
64 Target set phase to lOlb (reserved phase)
66 Target set message out phase
68 Selected target did not set any phase before releasing bus.
70 Target not following expected phase sequence.
72 Parity error detected during programmed
1/0
transfer.
80 Unexpected interrupt at start of DMA test
90 Target failed to set command phase.
92 Unexpected intenupt at start of command phase in-OMS test
94 1imeout waiting for OMA complete in command phase in OMA
test.
98 Wrong interrupt following command
in
O.MA test.
9A Scd_cnt not zero following command in OMA test.
9C DMA not complete after EOP command phase (ACK not clear soon
enough).
AO Status(dmaend) bit not cleared by clearing mode(dma) at start of
data in phase in OMA test.
A2 Target failed to set data in phase in OMA test.
A4 1imeout waiting for OMA complete in data in phase in OMA test.
A6 No status(dmaend) following data in phase in OMA test.
AS Wrong interrupt following data in phase in OMA test.
AA Scd_cnt not zero following data in phase in OMA test.
AC OMA not complete after eop in data in phase (ACK not clear soon
enough).
BO Status(dmaend) not cleared by clearing mode(dma) at start of status
phase in OMA test.