Digital Equipment VAXstation 3100 Maintenance Manual page 218

Console Commands 197
Register Value Register Value
PSL 041F.OOOO IPL lF
AS1LVL 4 SISR 0
ICCS
0 RXCS 0
TXCS 80
MAP EN
0
All other registers are unpredictable.
The defaults used to fill in unsupplied qualifiers for DEPOSIT and EXAMINE
commands are set to physical address. longword size, and address 0.
B.2.11 REPEAT
>>>REPEAT <command>
The console program repeatedly displays and executes the specified command.
The repetition is stopped when you type
lctrll [QJ.
Any valid console command
may be specified for the command witl1 the exception of the repeat command.
B.2.12 SET
>>> SET <parameter-name> <value>
Set the console NVR parameter to the indicated value. The following console
parameters and their acceptable values are defined:
Parameter-name
• BOOT -
Set the default boot device. The value must be a valid boot
device name as specified by tlle boot command. The only validation
done is to verify the fourth character in the device name is a decimal
number between zero and nine. Entering "." resets the boot device to
the default value which is ESAO.
Value
• DK.AxOO - RZ23, RZ24, or RZ55 on SCSI-A bus at address ID
x (0 to 7)
• MKAxOO - Tape drive on SCSI-A bus at address ID x (0 to 7)
• DUA2 - RX23 is system box on model 30 systems only
• ESAO - Ethernet booting device.
• DKBxOO - RZ23, RZ24, or RZ55 on SCSI-B bus at address ID
x
(0 to 7)