Digital Equipment VAXstation 3100 Maintenance Manual page 30

(
>>>
TEST 50
KA42-A Vl.0
ID 08-00-2B-02-CF-A4
MONO 0000.0001
CLK 0000.0001
NVR 0000.0001
DZ 0000.0001
Testing 9
00000001 00000001 00000001 00000001 00000001 000012AO
MEM 0008.0001
00800000
MM 0000.0001
FP 0000.0001
IT 0000.0001
STRG-1 7177.0001 Vl.O
00000000 00000000 00000960 00000000
SCSI-A 0808.0001 Vl.O
FFFFFFOS FFFFFFOS FFFFFFOS 00000001 FFFFFFOS FFFFFFOS FFFFFF03
SYS 0000.0000
8PLN 0000.0001 Vl.O
NI 0000.0001
>>>
Figure 1-4 Model 30 System Configuration Table with RX23 Drive
Any code in the configuration table other than 0000.0001 on the MONO, DZ,
MM, FP, IT, or SYS devices indicates a hard error and the system module
must be replaced for proper operation of the system. The other devices such
as CLK, NVR, MEM, STRG-1, SCSI-A, SCSI-B, and NI may have a code
other than (0000.0001) and may still operate normally. Go to the device's
troubleshooting section in Chapter 2 to determine whether or not the device's
code indicates a fault or a status for the device. Refer to Section 3.1 if you
need an explanation of bow to read the configuration table. Refer to Appendix
E if you need a detailed listing of the power-up error codes.
Since a 'l could indicate status information, some common power-up status
messages are defined as follows:
• Clock not set -
'l E 0040 0000.0005
This message indicates that the system clock has not been set. Setting the
clock is part of
the operating system software installation and cannot be
set while in console mode. Once the clock is set, this code will be cleared
the next time the clock circuits are tested.
• Low battery -
'l D 0050 0000.0005