Table of Contents
Advertisement
104 VS
3100
(Model
30)
System
NOTE
When reinstalling the system module, install the connector end first
through the openings in the rear of the box. Push the module back to
load the connector ground tabs and then snap the module onto both
locating standoffs. All screw holes will then be aligned.
CAUTION
During the next step, be careful not to bend the pins on the Ethernet
ID ROM.
9. Remove the Ethernet ID ROM (Figure 4-20) from the system module you
removed. Check the position of pin 1 (notched) on the ROM. Install the
ID ROM on the-new system
module.
UA-XOtol·
H
Figure 4-20 Ethernet ID ROM Location on System Module
4.2.10 Battery Pack Removal
1. Remove the system box cover (Section 4.2.1 ).
2. Remove the drive mowiting panel (Section 4.2.2).
3. Disconnect the battery cable from the system module (Figure 4-21).
Advertisement
Chapters
Table of Contents
Troubleshooting
