Digital Equipment VAXstation 3100 Maintenance Manual page 220

(
Console Commands 199
• A 14 sets the keyboard layout to Svenska.
• A 15 sets the keyboard layout to Vlaams.
• MOP - Set the network listener to be enabled or disabled. The
only acceptable values for this are listed as follows. If the Ethernet
self-test had failed, then this command is an illegal command. If the
nonvolatile RAM fails for any reason, the default value is set to 1
(enabled).
Value
• A 0 disables the network listener.
• A 1 enables the network listener.
• PSWD - Set the password for remote trigger verification. This
allows a user to set the password that will be verified if a remote
trigger is received by the network listener. An illegal command will
be displayed if the Ethernet self-test has failed or remote triggers are
not enabled. In order to set a new password, the password must be
known unless it is the first time a password is set, in which case only
a new password need be specified. There is no corresponding SHOW
command. For security reasons, the password is one-way encrypted
and cannot be displayed.
• SCSIA - Set the SCSI address ID of the SCSI-A controller. The
address ID of the controller should be an ID of 6. However, the
address ID can be changed for whatever reason using this command.
Valid address IDs are 0 to 7. Enter>>> SC SIA 6 to set the controller's
ID to 6.
• SCSIB - Set the SCSI address ID of the SCSI-B controller. The
address ID of the controller should be an ID of 6. However, the
address ID can be changed for whatever reason using this command.
Valid address IDs are 0 to 7. Enter>>> SCSIB 6 to set the controller's
ID to 6.
• TRIG - Set the remote trigger to be enabled or disabled. This allows
a remote system to request a local boot of the system. If the Ethernet
self-test has failed, then this is an illegal command. If the nonvolatile
RAM fails for any reason, the default value is set to 0 (disabled,
remote trigger is not allowed).