Additional Strg-1 System Exerciser Information - Digital Equipment VAXstation 3100 Maintenance Manual

32 Troubleshooting
Table
2-5
Self-Test Codes for the RX23 (OX00.0001)
Error Codes Description
of
EITOr Codes for Ellch Disk Drive
1 Good - No error for this drive.
2 Drive select error. Disk controller or the drive failed.
3 Read error during read test. The test diskette may not be formatted
with the
special
key. Run the test diskette formatter (TEST 72)
on the diskette, then retest the
RX23.
If this code is
listed again,
replace the diskette with another fonnatted test diskette
(T 72)
and
retest the RX23. Replace the drive if this code is listed again.
4 Read _ a fter write error. Replace the drive.
6 Drive failed to restore. Replace the drive.
7 Off-line - No drive installed, no diskette loaded in DUA2, or the
RX23
is
faulty.
8
Drive not done error. Replace the drive.
9 Invalid status from controller. STR0-1 controller failed or the
disJcene failed. Replace the diskette with another formatted· test
diskette (T 72) and retest the
RX23.
A Drive select timeout error. Replace the drive.
E _ Untesie.d-=-Dfiy:e_wwuiuUested becau5-e_of a hard error found on
the
STR0-1 controller. For example, FFF8.FFF8 indicates an error
on the STR0-1 controller and no drives were tested. Replace the
MSC module.
2.11.2 Addltlonal STRG-1 System Exerciser Information
Start the system exerciser for customer mode by entering TEST 0.
1
ne
customer mode exerciser does not perform writes to the RX23 diskette drive.
Start the system exerciser for Field Service mode by installing the loopback
connector on the communication port, then by entering TEST 80000106 and
then a 7 at the prompt (on just the RX23). The Field Service mode system
exerciser performs a complete read/write test and also performs a data transfer
test between the S1RG-1 controller and the RX23.
The results of the system exercise are d"splayed on the screen after each test
pass. Figure 2-5 shows the system exerciser display for the RX23 controller
and drive (S1RG-l).