Digital Equipment VAXstation 3100 Maintenance Manual page 165

144 Expansion Boxes
TT•_x1141_11
Figure 6-10 RZ55 Bezel Removal
9.
If
you have already repiace<i ti:Je eiectronics moduie on foe urivo, 1$tup ho10
and replace the whole drive. Otherwise replace the electronics module as
follows.
10. Carefully
apply
outward pressure to the bezel with your thu.-nbs unti! the
two bezel locking pins clear the holes in the frame. Note that the bezel
must ft.ex approximately 1/8 inch to clear the pins.
11. While the bezel is clear of the locking pins, slide it upward until movement
stops (about 3/8 inch). Then remove the bezel from the drive.
12. Remove the three screws (Figure 6--11).