Rwming Self-Test; Self-Test Diagnostic Commands - Digital Equipment VAXstation 3100 Maintenance Manual

10 Testing
This message indicates that the battery's charge is low which may be the
case when a system is first installed. Run the system for about 17 hours
to fully recharge the battery.
• No Ethernet cable (ThinWire) - ?? 1 OOCO 0000.7004
This message indicates that the Thin Wire Ethernet connector on the back
of the system is not terminated or that the Thinwire Ethernet cable is not
terminated properly.
• No Ethernet cable (standard) - ?? 1 OOCO 0011.700E
This message indicates that the standard Ethernet connector on the back
of the system is not terminated or that the standard Ethe.met cable is not
terminated properly.
• No heartbeat on standard Ethernet - 1 OOCO 0100.0001
This message indicates that the standard Ethernet is selected and
terminated properly, but the Ethernet network is not supplying the
necessary heartbeat signals to the system. This is normal if just the
lp_Qppa«~
connector is installed on the standard Ethernet connector.
• Graphics module -
?
4 OODO XXXX.0213
This message indicates that the two 75 ohm video cable terminators are
not insta!ied on
!he
color video cabie's red and bl•_•e
r.onnecinrs
wh~n using
a monochrome monitor.
1.3 Running Self-Test
Self-test allows you to test every device again after power-up tests are
co pJete. Devices can be tested individually (except for drives), a few at
a time, or all of them sequentially just like power-up tests.
1.3.1 Self-Test Diagnostic Commands
To individually test a device (drives are tested all together on theil' particular
bus), enter the (TEST or just (T), followed by a space and the test number of
the device you want tested. Table l-4 lists the devices and the test numbers
that test them. Figure
1- 5 shows
an e:itample of running self-test on an SCSI
us . All devices connected to the SCSI bus are tested and the results are listed
in the configuration table (TEST 50).