Digital Equipment VAXstation 3100 Maintenance Manual page 85

64 Utllltles
>»
TEST 50
M.42-A Vl.O
ID 08-00-2B-02-CF-A4
MONO 0000.0001
CLK 0000.0001
NVR 0000.0001
DZ 0000.0001
00000001 00000001 00000001 00000001 00000001 000012AO
MEM 0008.0001
00800000
MM 0000.0001
FP 0000.0001
IT 0000.0001
SCSI-A 0808.0001 Vl.O
FFFFFFOS FFFFFFOS FFFFFFOS 00000001 FFFFFFOS FFFFFFOS FFFFFF03 ..•
SCSI-B COC0.0001 Vl.O
FFFFFFOS FFFFFFOS FFFFFFOS 00000001 FFFFFFOS 01000001 FFFFFF03 •••
SYS 0000.0001
8PLN 0000.0001 Vl.O
NI 0000.0001
>>>
Figure 3-1 Example of the Configuration Table
NOTE
The 8PLN code will show a soft error (xxxx.0213) when using a
monochrome monitor without the 75 ohm terminators installed on the
video cable's red and blue cables.
The first line contains the CPU and the ROM version (KA42-A Vl.0).
The second line contains the Ethernet hardware address
(in
this example it
is ID 08-00-2B-02-CF-A4). The rest of the display contains the status/error
codes for the devices iosta1led on the system. The configuration table is built
during power-up testing and the codes are the result of the self-test and power-
up tesls. This configuration table is the only place the results of self-test are
indicated. It is updated. every time you run self-test. Additional codes on
the DZ, MEM, STRG-1, SCSI-A, and SCSI-B give a more detailed status on
these devices as listed. in the following section.