Digital Equipment VAXstation 3100 Maintenance Manual page 185

164 Expansion Boxes
6.3.3.2 TK50 Tape Drive Removal
1. Remove the TZK.SO controller board (Section 6.3.3.1).
2. Disconnect the power cable on the resistor load board that comes from
the power supply.
3. Remove the five shield screws (Figure 6-26).
UA
0
ltOHl-ll
Figure 6-26 TKSOZ Expansion Box Shield Screws
4. Disconnect the SCSI cable and the terminator, or both the SCSI cables
from the rear of the TK50Z expansion box.
5. Lift the shield up and off of the chassis.