Battery Pack Removal - Digital Equipment VAXstation 3100 Maintenance Manual

VS 3100 (Model 40) System 127
load the connector ground tabs and then snap the module onto both
locating standoffs. All screw holes will then be aligned.
CAUTION
Be careful not to bend the pins on the ROM.
9. Remove the Ethernet ID ROM (Figure 5-18) from the system module you
removed. Check the position of pin 1 (notched) on the ROM. Install the
ID ROM on the new system module.
l!THl!RNl!T
ID ROM
Figure 5-18 Ethernet ID ROM Location on System Module
5.2.1 O Battery Pack Removal
1. Remove the system box cover (Section 5.2.1).
2. Remove both of the drive mounting panels (Section 5.2.2).
3. Disconnect the battery cable from the system module (Figure 5-19).