Table of Contents
Advertisement
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If the server is in the rear 4 LFF drive configuration, remove the rear 4 LFF drive cage .
9. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
10. Remove the one-slot riser cage:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
One-slot primary/secondary riser cage
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide
66
Advertisement
Table of Contents
