HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 50

The rack rail option support is dependent on these two factors:
The height and weight of the chassis as determined by the front- and rear-end server configurations.
The depth of the chassis as measured from the edge of the front panel (without the front bezel) to the edge of the rear panel.
To ensure compatibility between the rack rails and the server, verify that the rail number labels on the chassis match the ones stamped on
the rails.
Rail number labels on the chassis
Rack mounting interfaces Rack mounting interfaces
The rack rails can be installed in a rack that has the following mounting interfaces:
Round-hole Square-hole
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates the type of mounting
interface for which the action illustrated in the image is valid.
Remove the middle cover Remove the middle cover
About this task About this task
This procedure applies to the GPU configuration.
Threaded round-hole
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 50