Table of Contents
Advertisement
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the rear 4 LFF drive cage .
9. Disconnect any internal cables that are connected to the expansion card.
10. Remove the NS204i-u + secondary low-profile riser cage:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
11. If installed, disconnect all cables from boot device and expansion card.
12. Remove the expansion card:
a. Pivot the riser cage to vertical position.
b. Open the retention latch (callout 1).
c. Remove the expansion card screw (callout 2).
Retain the screw. The screw will be used to secure the new expansion card spare.
d. Remove the expansion card from the riser cage (callout 3).
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide
127
Advertisement
Table of Contents
