HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 190

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the boot device cage assembly on top of the power supply cage Removing and replacing the boot device cage assembly on top of the power supply cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 190