HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 149

b. Remove the midplane drive cage .
9. If installed, remove the cable guards .
10. Remove the rear 4 LFF drive cage .
11. Remove the riser cage.
12. Remove the expansion card .
13. Remove the riser board.
Retain all screws. These screws will be used to secure the new riser board spare.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the PCIe5 x16 low-profile riser Removing and replacing the PCIe5 x16 low-profile riser
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 149