HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 161

Disconnect all front GPU riser cables from the system board.
11. Remove the front GPU cage .
12. If installed, remove the GPU.
13. Remove the GPU riser from the riser cage.
Retain all screws. These screws will be used to install the new spare GPU risers.
14. Disconnect the power cable from the riser.
Results Results
To replace the component, reverse the removal procedure.
Optical drive replacement Optical drive replacement
Subtopics Subtopics
Removing and replacing the optical drive from the LFF chassis Removing and replacing the optical drive from the LFF chassis
Removing and replacing the optical drive from the SFF chassis Removing and replacing the optical drive from the SFF chassis
Removing and replacing the optical drive from the LFF chassis Removing and replacing the optical drive from the LFF chassis
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 161