Table of Contents
Advertisement
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
12. Disconnect the signal and power cables from the boot device.
13. Remove the boot device cage assembly:
a. Remove screws from the riser cage (callouts 1 and 2).
Retain the screws. These screws will be used to secure the new boot device cage assembly.
b. Pull the cage assembly from the slot (callout 3).
14. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide
189
Advertisement
Table of Contents
