HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 126

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card from PCIe5 x16 low-profile riser Removing and replacing an expansion card from PCIe5 x16 low-profile riser
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 126