HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 164

T-10 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the fan cage.
9. Remove the midwall bracket .
10. Disconnect the SATA-power Y-cable from the optical drive .
11. Remove the screw (callout 1), and then remove the optical drive from the universal media bay (callout 2).
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 164