HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 46

Open the cable management arm Open the cable management arm
Procedure Procedure
1. Press and hold the blue PUSH PUSH button on the retention bracket.
2. Swing the arm away from the rear panel.
Extend the server out of the rack Extend the server out of the rack
Prerequisites Prerequisites
Before you perform this procedure, review the Rack warnings and cautions.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears are secured.
About this task About this task
WARNING: WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches. The inner rails could pinch
your fingers.
Procedure Procedure
1. If needed, loosen the shipping screws, and then use the chassis ear latches to slide the server out of the rack until the rail-release latches
are engaged.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 46