HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 282

marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible graphics card that supports this feature in the expansion slot.
Rear panel LEDs Rear panel LEDs
Item Item LED LED
1 Power supply
2 iLO status
3 iLO link
4 UID
System board components System board components
Status Status Definition Definition
Solid green
Off
Solid green
Flashing green
Off
Solid green
Off
Solid blue
Flashing blue
Off
The power supply is operating normally.
One or more of the following conditions exists:
Power is unavailable
Power supply failure
Power supply is in standby mode
Power supply error
The front I/O cable is disconnected.
Lined to network
Network active
No network activity
Network link
No network link
Activated
1 flash per sec—Remote management or firmware upgrade in
progress
4 flashes per sec—iLO manual reboot sequence initiated
8 flashes per sec—iLO manual reboot sequence in progress
Deactivated
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 282