HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 193

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the boot device cage assembly from the secondary three-slot riser Removing and replacing the boot device cage assembly from the secondary three-slot riser
cage cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 193