HPE ProLiant DL385 Gen11 Maintenance And Service Manual page 308

Internal cabling management Internal cabling management
Cabling diagrams Cabling diagrams
Storage cabling Storage cabling
Riser cabling Riser cabling
HPE NS204i Boot Device cabling HPE NS204i Boot Device cabling
System Insight Display cabling System Insight Display cabling
Chassis intrusion switch cabling Chassis intrusion switch cabling
Universal media bay cabling Universal media bay cabling
DisplayPort cabling DisplayPort cabling
Front I/O cabling Front I/O cabling
Power distribution board cabling Power distribution board cabling
Serial port cabling Serial port cabling
Optical drive cabling Optical drive cabling
OCP bandwidth upgrade cabling OCP bandwidth upgrade cabling
Cabling guidelines Cabling guidelines
Observe the following:
Some diagrams show alphabetical callouts A, B, C, etc. These callouts correspond to labels near the connectors on the cable.
The cable colors in the cabling diagrams used in this chapter are for illustration purposes only.
Observe all guidelines when working with server cables.
Before connecting cables Before connecting cables
Note the port labels on the PCA components. Not all these components are used by all servers:
System board ports
Drive and power supply backplane ports
Expansion board ports (controllers, adapters, expanders, risers, and similar boards)
Note the label near each cable connector. This label indicates the destination port for the cable connector.
Some data cables are prebent. Do not unbend or manipulate the cables.
To prevent mechanical damage or depositing oil that is present on your hands, and other contamination, do not touch the ends of the
connectors.
When connecting cables When connecting cables
Before connecting a cable to a port, lay the cable in place to verify the length of the cable.
Use the internal cable management features to properly route and secure the cables.
When routing cables, be sure that the cables are not in a position where they can be pinched or crimped.
Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server cable. Never bend power cords and server
cables tight enough to cause a crease in the sheathing.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 308