Table of Contents
Advertisement
3.3.17. Setting the Position of the Upconverted Image on the HD Raster
(Not on early versions)
The OUTPUT H POS and OUTPUT V POS menus allow the user to adjust the position of the upconverted
image on the output high definition raster. These menu items are not available on early versions that do
not have a gen lock reference. The values must be set separately for each OUTPUT ASPECT ratio and
VIDEO STANDARD combination.
OUTPUT H POS
Out H Pos: xx
OUTPUT V POS
Out V Pos: xx
3.3.18. Displaying The Firmware Version
The FIRMWARE VERSION menu allows the user to display the firmware version of the Upconverter
FIRMWARE
VERSION
Version 2.0
3.4.
ENGINEERING SETUP MENU
The Front panel Engineering Setup menu is available to configure advanced items, to update the
Upconverter firmware and reset the Upconverter to its factory defaults.
Proceed with Caution!
!
Improper use of the Engineering menu items can cause the Upconverter
application firmware to be erased.
The operation of the Engineering Setup menu is similar to the main menu system. It contains all the menu
items from the main Setup menu plus the additional engineering items. To access the Engineering Setup
menu press the ↑ key and the SETUP key at the same time and hold for 5 seconds. After 5 seconds, the
top-level item on the menu ( VIDEO OUTPUT ) will appear. The following section gives a brief description
of the additional items on the menu. Selecting one of these items will take you to the next menu level
where you can select and change parameter values. Sections 3.4.1 to 3.4.4 provide detailed descriptions
of each of the sub menus. The tables in sections 3.4.1 to 3.4.4 are arranged in an indented structure to
indicate the path taken to reach the control. Menu items or parameters that are underlined indicate the
factory default values.
INSTALLATION
HD9510UC High Definition Upconverter Manual
Sets the left edge of the upconverted image on the high definition raster.
Sets the top edge of the upconverted image on the high definition raster.
See Chapter 4 for information about updating the firmware version of the
Upconverter. The early versions of the upconverter will have firmware versions
1.xx and the later ones will have versions 2.xx.
Only qualified people should use these menu items.
Revision 1.1.1
Page 3-13
Advertisement
Table of Contents
