Table of Contents
Advertisement
VIDEO TYPE
LTC LEVEL
VITC DEL START
VITC DEL END
CEN COLOUR PHASE
REFERENCE MODE
DAYLIGHT SAVING
GPI1 ASSIGNMENT
GPI2 ASSIGNMENT
GPO1 ASSIGNMENT
GPO2 ASSIGNMENT
GPO DURATION
SERIAL BAUD RATE
SERIAL TEST
SERIAL MODE
XRAM TEST
DISPLAY LEVEL
LVS ADDRESS
ON AIR MODE
SDI VBLANK END
NTSC SETUP
FONT DOWNLOAD
SOFTWARE VERSION
FACTORY RESET
Table 3-2: Overview of the 8010-SIE Engineering Menu System
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
Sets the Video standard for the encoder
Sets the amplitude level of the LTC output
Sets the first line that will be blanked by the VITC deleter
Sets the last line that will be blanked by the VITC deleter
Sets an offset from the Colour reference input
Selects the generator framing reference
Sets whether the Generator time will be adjusted for DST or not
Assigns the function for General Purpose Input 1
Assigns the function for General Purpose Input 2
Assigns the function for General Purpose Output 1
Assigns the function for General Purpose Output 2
Sets the duration of the momentary general purpose outputs
Sets the baud rate of the serial port
Turns on a Serial Port output test
Sets the mode of the serial port
Turns on a RAM hardware test
Sets the brightness level of the Front panel display
Blanks Character windows on the SDI output when 'On Air'
Sets the last line that will have the SDI V bit set to zero
Selects if Setup will be applied on the optional analog NTSC output.
Used to Download new character fonts
Displays the current firmware version of the encoder
Resets the encoder to its Factory default condition
Revision 2.2
Page 3-19
Advertisement
Table of Contents
