Table of Contents
Advertisement
7-20 Routing and splicing the fiber cable
Procedure 7-3
Routing the fiber patch cords from the ABM to the FPP
This procedure explains how to route the protected fiber optic patch cords from
the Access Bandwidth Manager (ABM) shelf to the fiber management system
such as an ADC fiber patch panel (FPP) in the S800A cabinet.
Table 7-4 shows where to find information regarding fiber routing for:
•
•
•
Table 7-4
Additional fiber routing and splicing information
If you are
Routing the OSP fiber cable directly into the
cabinet to an internal fiber management
system such as an ADC fiber patch panel for
bonding and grounding
Routing the OSP fibers into the cabinet to the
fiber management system with the cable
bonded and grounded in the termination
compartment
Routing the fiber patchcords or pigtails directly
to the ABM when the fiber management
system is located external to the cabinet
AccessNode 323-3001-210 Issue 1.0
fibers to the FPP from the OSP cable that is bonded and grounded in the
termination compartment
fiber patch cords to the FPP from locations external to the S800A cabinet
such as a customer owned manhole
fiber patch cords to the ABM from locations external to the S800A cabinet
such as a customer owned manhole
—continued—
Additional information can
be found in
Procedure 7-1 on page 7-5
Procedure 7-2 on page 7-15
Procedure 7-4 on page 7-32
Advertisement
Table of Contents
