Alarm Wiring - Nortel SONET AccessNode 800A Series Manual

13-32 Cabinet and equipment wiring and cabling

Alarm wiring

Alarm wiring connects to the BIP pin field located on the front left of the BIP
faceplate from the equipment external to the AccessNode.
Equipment external to the AccessNode is alarmed through the BIP via the pin
field (see Table 13-7). Reference the specific shelf wiring and cabling section
in this chapter for more information regarding alarm wiring.
The alarms are provisioned via AccessNode software. Refer to NTP
323-3001-302, System Administration Procedures, in Operations,
Administration, and Provisioning, Volume 4A, for alarm provisioning
information.
Alarm cabling and wiring is also detailed in Table 13-10 on page 13-43.
Table 13-7
Alarm wiring for E2A external connections
Scan Alarm
point description
1 AC FA
1 AC FA RET
2 LVA
3 REMOTE ACO
4 DOALM
5 LTEMP ALM
6 FA
7 PWR MN
8 PWR MAJ
9 RPTR FA
9 RPTR FA RET
10 RPTR LOS
10 RPTR LOS RET
11 RPTR ERR
11 RPTR ERR RET
LGND Alarm Reference
AccessNode 323-3001-210 Issue 1.0
Alarm
severity Source
Minor DC distribution shelf
DC distribution shelf
Major DC distribution shelf
N/A A/N
Minor Cabinet
Major Sensor
Major BBP/DC distribution shelf
Minor DC distribution shelf
Major DC distribution shelf
Minor RPTR 1, 2
RPTR 1, 2
Minor RPTR 1, 2
RPTR 1, 2
Minor RPTR 1, 2
RPTR 1, 2
All of the above
Source BIP Pin
connector and field pin
pin number number
14 1
15 2
3 3
4
7 6
7
5 9
1 10
2 12
Pos. 23, Pin 14 13
Pos. 23, Pin 16 14
Pos. 23, Pin 8 15
Pos. 23, Pin 10 14
Pos. 23, Pin 2 16
Pos. 23, Pin 4 17
Per Application 5, 8,
11, 18