Table of Contents
Advertisement
Procedure 7-4 (continued)
Routing fiber to the ABM when no FPP is installed
Prerequisites for installation
The prerequisites for routing the fiber patch cords include:
•
•
•
•
Precautions
Read the following cautions before beginning the procedure:
AccessNode Series 800A Outside Plant Cabinet Installation 323-3001-210 Issue 1.0
The cabinet has been mounted on the selected concrete pad as defined in
Chapters 1 through 6 of this practice.
All hardware and materials are available and have been checked for
completeness and readiness for the installation.
All the required drawings, local installation instructions, job
specifications, and other documentation are available and ready for use.
A fiber management system has been used in a location external to the
S800A cabinet and only fiber patch cords or pigtails are to be run into the
cabinet.
CAUTION
Risk of damage to fiber optic patchcords
Handle the fibers with extreme care. Never bend the cables
into a curve with a radius smaller than 3.0 inches (76 mm).
Tighten connections to the optical units finger tight only.
DANGER
Laser radiation hazard
Avoid direct exposure to fiber or optical connector ends
where the laser signal can be reached. Laser radiation is
present and can cause serious eye damage.
Get immediate medical attention if a glass chip becomes
lodged in the eye area.
CAUTION
Clean all optical connectors
Dust can adversely affect optical connector performance.
Clean all connectors before inserting the connectors into the
mating sleeves. Use clean dust caps when connectors are not
in use.
Routing and splicing the fiber cable 7-33
—continued—
Advertisement
Table of Contents
