Table of Contents
Advertisement
Procedure 2-5
Enabling the door locks
Use this procedure to enable the S800A door locks if tool locks are required.
If the internal door locks are not used, it is the responsibility of the operating
company to furnish pad locks for all four doors.
Prerequisites for installation
The operating company is responsible for the choice of site and compliance
with local regulations such as the applicable electrical codes, right-of-way
easements, and noise requirements.
Installation procedures assume the following:
•
•
•
•
•
Tools required
When the door locks are enabled, the front and rear electronics and the ac
compartment doors may be unlocked with an:
•
The outside plant compartment may be unlocked with a:
•
AccessNode Series 800A Outside Plant Cabinet Installation 323-3001-210 Issue 1.0
All hardware and materials are available, and have been checked for
completeness and readiness for the installation.
The correct cabinet pad has been poured at the site.
The cabinet pad has been prepared as described in Chapter 1, "Installing
the pad" and has cured.
The required drawings, local installation instructions, job specifications,
and other documentation are available and ready for use.
Procedure 2-1 through Procedure 2-4 in this chapter have been completed.
AT&T 840841324 or equivalent hex key tool
216-type can wrench or 10660-001 Harris can wrench
—continued—
Installing the cabinet 2-31
Advertisement
Table of Contents
