Table of Contents
Advertisement
7-32 Routing and splicing the fiber cable
Procedure 7-4
Routing fiber to the ABM when no FPP is installed
This procedure explains how to route fiber optic patch cords from an external
fiber management system to the access bandwidth manager (ABM) shelf in the
S800 cabinet.
Table 7-6 shows where to find information regarding fiber routing for:
•
•
•
Table 7-6
Additional fiber routing and splicing information
If you are
Routing the OSP fiber cable directly into the
cabinet to an internal fiber management
system such as an ADC fiber patch panel for
bonding and grounding
Routing the OSP fibers into the cabinet to the
fiber management system with the cable
bonded and grounded in the termination
compartment
Routing the fiber patchcords from the ABM to
the fiber management system in the cabinet
AccessNode 323-3001-210 Issue 1.0
fibers to the FPP from the OSP cable that is bonded and grounded in the
termination compartment
fiber patch cords to the FPP from locations external to the S800A cabinet
such as a customer owned manhole
fiber patch cords to the ABM from locations external to the S800A cabinet
such as a customer owned manhole
—continued—
Additional information can
be found in
Procedure 7-1 on page 7-5
Procedure 7-2 on page 7-15
Procedure 7-3 on page 7-20
Advertisement
Table of Contents
