Table of Contents
Advertisement
4-20 Installing the OSP cables
Procedure 4-5
Applying a moisture barrier to the air-core cable
This procedure explains how to apply a moisture barrier to air-core cables
pulled into the S800A cabinet.
Precautions
The following safety precautions should be observed at all times during the
cable sheath bonding and grounding procedures:
•
•
Prerequisites
Ensure that Procedure 4-1 on page 4-4 through Procedure 4-4 on page 4-16
have been completed.
Tools required
There are no special tools required to perform this procedure.
Material required
•
•
AccessNode 323-3001-210 Issue 1.0
Note: A moisture barrier is only applied to air-core cable. Disregard this
procedure if you are using filled cable.
No equipment should be installed until the cabinet is firmly secured to its
mounting pad, as described in Chapter 2, "Installing the cabinet".
Do not open the front or rear doors unless the cabinet is firmly secured to
the mounting pad.
CAUTION
Safety hazard
Always follow all the recommended safety procedures when
performing these steps.
encapsulating material as per Bell System Practices (BSP) Section
631-600-305 Issue 1, November 1972 or the procedure enclosed in the
8962 Multi-mold package
electrical tape
—continued—
Advertisement
Table of Contents
