Advertisement
Parameter details
0: Relative center frequency
1: Relative maximum frequency
Hundreds place: preset frequency enable
0: not enabled
1: enable
Thousands: reserved
Code
Name
(Addr.)
F08.32
Swing frequency preset
(0x0820)
frequency
STOP
F08.33: Swing frequency preset frequency waiting time
Code
Name
(Addr.)
F08.33
Swing frequency preset
(0x0821)
frequency waiting time
STOP
F08.34: Wobble amplitude
Code
Name
(Addr.)
F08.34
Swing
frequency
(0x0822)
amplitude
STOP
F08.35: Kick frequency
Code
Name
(Addr.)
F08.35
(0x0823)
Kick frequency
STOP
F08.36: Triangle wave rise time
Code
Name
(Addr.)
F08.36
(0x0824)
Triangle wave rise time
STOP
F08.37: Triangle wave fall time
Code
Name
(Addr.)
F08.37
(0x0825)
Triangle wave fall time
STOP
11.11 F09 Group: Reserved
11.12 F10 Group: Protection parameters
F10.0x group: current protection
Code (Addr.)
Name
Adjustable attribute
F10.00
Overcurrent
(0x0A00)
suppression
RUN
Note: This function code selection is valid only for the VF control mode, and the overcurrent suppression function for vector control is always valid.
0: Inhibition is always valid
When the drive reaches the overcurrent suppression point when the drive is adding, subtracting and constant speed, the drive reduces the output current
through software control (pause acceleration, deceleration, lowering or raising the output frequency, etc.), and the output current is reduced to overcurrent
suppression. When the point is below, the drive works normally.
1: Acceleration/deceleration is valid, constant speed is invalid
The overcurrent suppression function is valid during the acceleration/deceleration of the drive, and the overcurrent suppression is invalid at constant speed.
AC10 Series Frequency Inverter Technical Manual
Content
V/F SVC
Swing frequency preset frequency
Content
V/F SVC
Swing frequency preset frequency waiting time
Content
V/F SVC
Set the swing frequency amplitude
Content
V/F SVC
Set the kick frequency
Content
V/F SVC
Set the triangle wave rise time
Content
V/F SVC
Set the triangle wave fall time
Content
V/F SVC
Automatically limit the output current to not exceed the set overcurrent
suppression point to prevent overcurrent and trigger overcurrent fault
0: Inhibition is always valid
1: Acceleration/deceleration is valid, constant speed is invalid
158
Factory setting
(Setting range)
0.00Hz
(0.00 ~ F01.12)
Factory setting
(Setting range)
0.0
(0.0 ~ 3600.0s)
Factory setting
(Setting range)
10.0%
(0.0 ~ 50.0%)
Factory setting
(Setting range)
10.0%
(0.0 ~ 50.0%)
Factory setting
(Setting range)
5.00s
(0.0 ~650.00s)
Factory setting
(Setting range)
5.00s
(0.0 ~650.00s)
Factory setting
(Setting range)
0
(0 ~ 1)
Advertisement
