Table of Contents
Advertisement
RIGOL
Waveform Analysis
This function is used to analyze the recorded waveform. Press Utility Record
Mode and use
point, the screen is divided into two display areas as shown in the figure below.
Settings and Results
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
Trace: perform analysis on the basis of the templet selected by users. For
the detailed information, refer to "Analysis Based on Trace".
Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For the detailed information, refer to "Analysis Based on
Pass/Fail Mask".
2. Source
Press Source to select the channel (CH1 or CH2) to be analyzed.
Note: Only currently enabled channels can be selected.
10-8
to select "Analyze" to open the waveform analysis menu. At this
Templet Display Current Frame
Figure 10-3 Waveform Analysis
Chapter 10 Waveform Record
DS2000E User's Guide
Advertisement
Table of Contents
